Create And Manage A Twist Group; Establishing A Twist Group - Current E-WAND Installation Manual And User's Manual

Set the Final Position- Full Open
in the OPPOSITE direction [Fig. 14.1]
Twist the E-Wand TWIST HANDLE
OPEN position. Press and hold the
to move the slats back to the FULL
slats begin to move [Fig. 14.2].
PROGRAMMING BUTTON b
The slats will automatically move DOWN
OR LEFT and back to the FULL OPEN
position to verify that the positions
positions. have been set properly and that you
have completed programming the slat
Note: When twisting to the final position, if you move past the full open
partially unscrewing and re-tightening the battery cap. You have successfully position, do not twist the opposite way back to full open. Instead, restart
power cycled when you hear a tune.
programming. To get out of programming mode, power cycle the unit by
f
until the
Figure 14.1;
Twist Blinds to Push and Hold
Full Closed
16
You may create a Twist Group prior to or after installation and
programming. We recommend linking E-Wands prior to installation on
challenging to reach windows.
Figure 14.2;
placed in the group. A Twist Group allows you to group multiple E-Wands together so each will
Programming
respond to the manual twist movement given to any other E-Wand you have
Button
Place the E-Wands you wish to group in Pairing Mode
On the E-Wands you wish to group
together, one by one, press and hold the
[Fig. 15.1]. PROGRAMMING BUTTON b until you
hear a SINGLE BEEP (1), then release
Create and manage A
TWIST GROUP
(OPTIONAL)

Establishing a Twist Group

17
Figure 15.1; Press and Hold
Programming Button