Vertical Blinds Installation Guide - Current E-WAND Installation Manual And User's Manual

Make Any Necessary Adjustments
connection to the header. Based on the
results of the two tests [Fig. 3.3 and The blind mount must have a secure
Fig. 3.4], it may be necessary to add the
attachment outward [Fig. 4.1]. supplied EXTRA ADHESIVE STRIPS F to
your blind's header to build the mounting
If the HORIZONTAL BLIND MOUNT B
HORIZONTAL BLIND MOUNT B to fit extends beyond the top or the side of the
blind's header, use scissors to trim the [Fig. 4.2]. If you have a valance, make sure
the top of the neck of the HORIZONTAL
below the bottom of the valance.
BLIND MOUNT B is even with or slightly
Secure Blind Mount
Now that you have determined the final
position of the HORIZONTAL BLIND
MOUNT B , verify the header is clean
and dry and that the tube of the blind
adhesive strip [Fig. 5.1] and firmly press mount is snapped into place on the
to attach it to the blind's header. E-Wand, then remove the backing on the
You have now completed installing your E-Wand. You may now proceed
to Programming the E-Wand [Pg. 13].
Figure 4.1; (Optional) Build out Header
Figure 4.2; (Optional) Trim Blind Mount
to Fit
Figure 5.1; Remove Backing from
Adhesive Strip to Attach it to Header
10

VERTICAL BLINDS INSTALLATION GUIDE

blinds. If there is significant resistance you may need to contact your blind Before installing the E-Wand, make sure you are able to freely tilt your blinds
manufacturer. The E-Wand is not compatible with vertical blinds that use in both directions by turning the twist wand that originally came with your
a rope or chain to tilt the slats.
Make sure the blind slats are uniformly opened in the tilted fully opened
position, then remove the original manual tilt wand.
Remove Twist Wand
Remove the manual twist wand from the vertical blinds.
Install the Vertical Blind Mount
Install the VERTICAL BLIND MOUNT C
until it fits snuggly on the E-Wand frame on the E-Wand by sliding the clear plastic
bellows over the ATTACHMENT HOOK a [Fig. 6.1]. Install the mount so that the
of the room.
sensor switches will be facing the inside
Attach the E-Wand to the Vertical Blind
E-Wand ATTACHMENT HOOK a . Hook Pull down on the VERTICAL BLIND
MOUNT'S C bellows to expose the
the existing blind's tilt gear stem [Fig.
7.1] the E-Wand ATTACHMENT HOOK a onto
Figure 6.1; Install Blind Mount
Figure 7.1; Hook on E-Wand
11