Current E-WAND Installation Manual And User's Manual page 8

Place the E-Wand into Slat Position Programming Mode
To place the E-Wand into the Slat Position
hear a DOUBLE BEEP(2), then release Programming Mode, press and hold the
PROGRAMMING BUTTON [Fig. 10.1]. b until you
(2), you will hear a SINGLE BEEP (1).
Note: Prior to hearing a DOUBLE BEEP After hearing the DOUBLE BEEP (2),
release.
Programming Mode.
The E-Wand is now in Slat Position
Set the First Position- Full Closed (Down for Horizontal
Blinds or Left for Vertical Blinds)
[Fig. 11.1] to move the slats of the blind
Twist the E-Wand TWIST HANDLE
then release the TWIST HANDLE
to the FULL DOWN OR LEFT position,
Be careful not to over tighten slats, as
over tightening can cause damage to
the blind.
Press and hold the PROGRAMMING BEEP (1) [Fig. 11.2], then release.
BUTTON b until you hear a SINGLE
Figure 10.1; Press and Hold
Programming Button
f
f .
Figure 11.1; Figure 11.2;
Twist Blinds to Push and Hold
Full Closed Programming
Button
14
Set the Second Position- Full Open
[Fig. 12.1] in the OPPOSITE direction than
Twist the E-Wand TWIST HANDLE the first phase of programming to move
release the TWIST HANDLE f .
the slats to the FULL OPEN position, then
BUTTON b . You will hear a DOUBLE
Press and hold the PROGRAMMING BEEP (2) [Fig. 12.2], then release.
Note: During twisting, if you move past
the full open position, do not twist
the opposite way back to full open.
Instead, restart programming. To get
re-tightening the battery cap. You have out of programming mode, power cycle
the unit by partially unscrewing and
a tune.
successfully power cycled when you hear
Set the Third Position- Full Closed (Up for Horizontal Blinds
or Right for Vertical Blinds)
again in the SAME direction [Fig. 13.1]
Twist the E-Wand TWIST HANDLE
position. Be careful not to over tighten
so the slats reach the FULL UP OR RIGHT
the slats.
BUTTON b . You will hear a TRIPLE
BEEP (3) [Fig. 13.2], then release. Press and hold the PROGRAMMING
f
Figure 12.1; Figure 12.2;
Twist Blinds to Push and Hold
Full Open Programming
Button
f
Figure 13.1; Figure 13.2;
Twist Blinds to Push and Hold
Full Open Programming
Button
15