Current E-WAND Installation Manual And User's Manual page 16

Hide thumbs Also See for E-WAND:
Table of Contents

Advertisement

SAFETY INFORMATION
WARNING
Read all warnings and instructions prior to installing the E-Wand. Failure to follow these
instructions may result in property damage or serious personal injury.
Do not use the E-Wand for anything other than its intended use. Any usage of the parts of
CAUTION
this kit outside of its intended purposes in not covered under the warranty.
CAUTION
Existing blinds may have sharp edges. Use gloves to prevent cuts or abrasions whenever
removing or reinstalling blinds.
FCC: 2AJXXCP16E0060
Model: CP16E0060
IC: 22151-CP16E0060
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
FCC STATEMENT
1.
This device may not cause harmful interference, and
two conditions:
2.
This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by Current Products Corp.
could void the user's authority to operate the equipment.
30
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
NOTE: This equipment has been tested and found to comply with the limits for a Class B
communications. However, there is no guarantee that interference will not occur in
equipment generates, uses, and can radiate radio frequency energy and, if not installed
a particular installation. If this equipment does cause harmful interference to radio or
and used in accordance with the instructions, may cause harmful interference to radio
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
Reorient or relocate the receiving antenna.
measures:
Increase the separation between the equipment and receiver.
which the receiver is connected.
Connect the equipment into an outlet on a circuit different from that to
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can
RF WARNING STATEMENT
be used in portable exposure condition without restriction.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
IC STATEMENT
subject to the following two conditions: (1) this device may not cause interference, and (2)
operation of the device.
this device must accept any interference, including interference that may cause undesired
radio exempts de license. L'exploitation est autorisee aux deux conditions suivantes: (1)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
ettre le fonctionnement.
tour brouillage radioélectrique subi, même si le brouillage est susceptible d'en comprom-
ment. This equipment is in direct contact with the user's body under certain operating
conditions. This transmitter must not be co-located or operating in conjunction with any
This equipment complies with the radiation exposure limits in an uncontrolled environ-
other antenna or transmitter.
non controlé. Cet équipment est en contact direct avec le corps de l'utilisateur dans des
conditions de fonctionnement normals. Cet émetteur ne doit pas être co-localisées ou
Cet équipment est conforme aux limites d'exposition aux radiations dans un environment
opérant en conjonction avec tour autre antenne ou transmetteur.
31

Advertisement

Table of Contents
loading

Table of Contents