Other Procedures; Setting The Preferred Closed Position; Realign Your E-Wand; Master Reset Your E-Wand - Current E-WAND Installation Manual And User's Manual

Other Procedures

Setting the Preferred closed position

in a direction different than the direction you prefer (i.e. up or down on
When using the automated features, the E-Wand may close the blinds horizontal blinds, or left or right on vertical blinds). To change the preferred
closed position:
closed position, then release.
Twist the E-Wand TWIST HANDLE f until the slats reach your desired
you hear a QUADRUPLE BEEP (4). The E-Wand will now close to this set
Press and hold the PROGRAMMING BUTTON b on the E-Wand until
position when closed by sensor triggered events.

Realign YOUR E-Wand

has changed over time from it's originally programmed position. If you notice
Based on the construction of your blinds, you may notice the full open position
slat positions.
this occurrence, you can simply realign your originally programmed E-Wand
position you consider to be FULL OPEN.
Move the E-Wand manually by twisting the TWIST HANDLE f to the
SEXTUPLE BEEP (6), then release. Your E-Wand has now been realigned
Press and hold the PROGRAMMING BUTTON b until you hear a
to it's originally programmed positions.
22
Master reset is performed to return an E-Wand to its factory default settings.

MASTER RESET YOUR E-Wand

the memory of the E-Wand.
All twist groups, paired remotes, and positional settings will be removed from
QUINTUPLE BEEP (5), then release. To confirm you want to perform a
Press and hold the PROGRAMMING BUTTON b until you hear a
master reset, the E-Wand will play a series of monotone beeps.
b again until you hear a SINGLE BEEP (1). Another short tune will play,
After you hear the beeps, press and hold the PROGRAMMING BUTTON
and you will have successfully performed a master reset.
beeps. Master reset mode can be escaped by waiting until the mode times out,
or by twisting the E-Wand TWIST HANDLE f after hearing the monotone

SETTING THE FAVORITE POSITION

(for the remote control)
the user's favorite position. The FAVORITE Button on the remote control allows the user to program a slat
position unique to the user which moves all slats included on that channel to
reached.
Twist the E-Wand TWIST HANDLE f until the desired position is
you hear a TRIPLE BEEP (3), then release.
Press and hold the PROGRAMMING BUTTON b on the E-Wand until
position. Each E-Wand can be set to have different favorite positions.
Your FAVORITE Button will now move that blind to the programmed favorite
FAVORITE Button on your remote. All blinds on that channel should move to
their programmed favorite position.
After the E-Wand is set, test by moving your blinds, then pressing the
23