Sharp XG-P560W Operation Manual page 22

Quick Start
4.
Adjust the angle
Adjust the projector angle:
• • • • • Shift the lens horizontally and vertically.
1 1 1 1 1 Press H&V LENS SHIFT on the projector or
on the remote control.
2 2 2 2 2 Press ', ", \ or | on the projector or the
remote control.
• • • • • Adjust the projector angle by rotating the adjust-
ment feet.
5.
Adjust the focus and the zoom
1 1 1 1 1 Press FOCUS +/– on the projector or on the remote control to adjust the focus.
2 2 2 2 2 Press ZOOM +/– on the projector or on the remote control to adjust the zoom.
6.
Correcting the image distortion due to the projection angle
1 1 1 1 1 Press KEYSTONE on the projector or on the remote control.
2 2 2 2 2 Press ENTER on the projector or on the remote control.
3 3 3 3 3 Press ', ", \ or | to move the position for the upper left of the image.
4 4 4 4 4 Press ENTER to set the position.
5 5 5 5 5 Repeat the same procedure with the positions for the upper right, lower right and lower left of the image.
• • • • • When the position of the lower left is set, the correction is made and the display disappears.
7.
Select the input mode
Press INPUT on the projector or COMPUTER1 on the remote control to select the "COMPUTER1" mode.
On the
projector
• • • • • When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode and then press ENTER.
• • • • • When using the remote control, press COMPUTER1/2, DVI, HDMI, VIDEO or S-VIDEO to switch the input mode.
8.
Turn the power off
Press STANDBY on the projector or on the remote control. While the confirmation message is displayed,
press STANDBY again.
• • • • • You can unplug the power cord even if the projector is operating.
• • • • • Even if you unplug the power cord from the AC outlet, the cooling fan continues to run for a while.
-20
INPUT list
On the remote
control
" " On-screen display " "
"
On-screen display (RGB)
Pages 29, 30
Page 31
Page 32
Page 36
Page 28