Checking The Input Signal; Auto Sync Adjustment; Setting The Auto Sync Display Function - Sharp XG-P560W Operation Manual

Computer Image Adjustment ("Fine Sync" menu)

5 5 5 5 5 Checking the Input Signal

You can check the input signal information.

6 6 6 6 6 Auto Sync Adjustment

Used to automatically adjust a computer image.
Selectable items
Auto Sync adjustment is not automati-
Off
cally performed.
Auto Sync adjustment will occur when
Normal
the projector is turned on or when the
input signals are switched, when
connected to a computer.
High Speed
"Normal" takes more time than "High
Speed" for more accurate Auto Sync
adjustment.
Note
• Auto Sync adjustment is also performed by
pressing AUTO SYNC on the projector or on
the remote control.
• The Auto Sync adjustment may take some time
to complete, depending on the image of the
computer connected to the projector.
• When the optimum image cannot be achieved
with Auto Sync adjustment, use manual adjust-
ments. (See page 53.)
• When AUTO SYNC is pressed while "Auto
Sync" is "High Speed" or "Off", Auto Sync will
be executed in "High Speed" mode. If the but-
ton is pressed again within one minute, Auto
Sync will be executed in "Normal" mode.
-54
Description
Menu operation
7 7 7 7 7 Setting the Auto Sync
Display Function
Used to set the display during Auto Sync.
Selectable items
The image set as a background image
Background
is projected. See page 58.
The computer image being adjusted is
Adjusting Disp.
displayed.
Page 47
Description