Single
Adjusting Images
Gamma Correction
Changing the gamma value adjusts the tone of an image on the screen.
This function is only available in the "Single Projector Operation Mode".
Before Adjusting
G Use the projector's Gamma button to set the CUSTOM mode.
G Infrared communications (IrCOM) cannot be used when performing
1
gamma correction. Connect a serial cable or LAN cable to the projector
and the PC
(page
10), then proceed to Gamma Correction.
Select the
"Gamma
See section "Opening Modes"
| The "Gamma Correction" window will open.
3
4
1
2
5
1
Specify the source of the image. The default setting is
"COMPUTER"
2
Each of these colors except "WHITE" can be adjusted respectively.
As you adjust "WHITE", the values of the other three colors will be
offset.
Correction" mode.
(page
20).
76
6