Multi
Backup Function
This function automatically turns on the projector assigned in advance
as the backup projector, when the projector goes into standby due to a
malfunction.
When the backup projector autostarts, the settings of the projector in
which the error occurred are suitably sent to the backup projector,
therefore the interruption of the presentation is reduced to a minimum.
G This function can only be used when this software is running on a
G This function can only be used with the XG-V10 Series, the XG-P20X or
G The backup projector will restart in the event of the following errors.
G The settings sent from the projector in which the error occurred to
G Assign a projector that is normally in the standby mode as the backup
Backup Function Settings
1
1
personal computer.
the XG-P25X.
Internal temperature error
Cooling fan error
Filter cover error
Lamp burnout error
the backup projector are as follows:
The selected INPUT
Signal Type information (RGB/COMPONENT/VIDEO)
RESIZE information (Aspect ratio)
Special Mode information
Video System information
projector. Note that images other than the ones you expect may be
displayed when the backup function is activated if a projector that is
normally used is accidentally assigned as the backup projector.
Select "Projector Setting" from the "File" menu.
1
Backup function enable/disable check box
2
Backup projector selection pull-down menu
56
2