Installing Your New Appliance - Electrolux ETB4600C User Manual

10 www.electrolux.com

3. INSTALLING YOUR NEW APPLIANCE

Unpacking
ENVIRONMENT
Most of the packing materials are
recyclable. Please dispose of those
materials through your local recycling
depot or by placing them in ppropriate
collection containers.
Important – check for any damages or
marks. If you find the refrigerator is damaged or
marked, you must report it within 7 days should
you wish to claim for damage/ marks under the
manufacturers warranty. This does not affect
your statutory rights.
Clean your refrigerator thoroughly following
the instructions in the "Cleaning" section and
wipe off any dust that has accumulated during
shipping.
Locating the refrigerator
CAUTION
Automatic aerosol systems (such as
insect control) should not be located
adjacent to the product as the spray
may cause long term damage to the
external plastics of he appliance.
Do not put the refrigerator in a location that
is too cold or is unprotected, for example in a
garage or on a veranda. The
ambient temperature should be above 10°C.
Put the refrigerator in a dry place avoiding
areas of high moisture or humidity.
Ensure the refrigerator is located on an even
surface.
Adequate ventilation around your refrigerator
The diagram below shows the recommended
airspace to allow for ventilation of your
refrigerator.
minimum
minimum
If you have a cupboard above the refrigerator
with a rear gap of less than 100 mm (Y) ,
recommended clearance at the top of the
minimum
refrigerator increases from 30mm to 70mm (X)
minimum.
When positioned in a corner area, spacing of
at least 350mm on the hinge side will allow the
doors to open enough to enable the removal of
bins and shelves.
NOTE: Doors are designed to sit proud of
cabinetry (not flush). The clearances shown
above are the recommended minimum
clearances.
The clearance at the rear should not exceed
75mm.
Installing your refrigerator
1. Roll the refrigerator into place.
The rollers are designed for forward or
backward movement only. They are not
castors. Moving the refrigerator sideways
may damage your floor and the rollers.
Before moving your refrigerator ensure
height adjusting nut and the stability foot
are fully wound up off the floor.
2. Wind the large height adjusting nutunder
door hinge down until the refrigerator is
tilted back by 10mm (see diagram).
nut
nut
3. Wind the large height adjusting nut on the
nut
handle side down until the refrigerator is
level and stable. If you have difficulty
winding the nut or height adjusting foot
down, have someone tilt the refrigerator
back so you have better access.
4. Check the alignment of the refrigerator to
the surrounding cupboards to see if it is
level. You can adjust the level as detailed in
step 2 and 3.