Electrolux ETB4600C User Manual page 24

24 www.electrolux.com
CONCERN
Occasional gurgling, similar
to water boiling.
Rattling and other noises.
Crisper Operation
CONCERN
Excess moisture build up in
crisper
It is normal for there to
be some moisture and
humidity in the crisper bin.
Crisper bin can not be
removed
Freezing items in the crisper
Refrigerator operation
CONCERN
Appliance will not run
It is normal for the freezer
fan not to operate during
the automatic defrost cycle,
or for a short time after the
appliance is switched on.
Compressor motor seems
to run too long
At normal room
temperatures, expect your
motor to run about 40%
to 80% of the time. Under
warmer conditions, expect
it to run more often.
WHAT TO DO
Nothing. As each cycle ends, you may hear a gurgling sound due
to the refrigerant flowing in your refrigerator system.
Nothing, this is normal as your new refrigerator uses high efficiency
fans to circulate air. Fan speed and noise may increase during
periods of heavy usage or hot weather.
• Ensure that the cabinet is level and stable, refer to Installation
Instructions
• Check the surrounds of the appliance to ensure there is nothing
touching or placed on top of the appliance.
• Ensure that contents of the appliance are not placed in such a
way that they are vibrating (such as bottles).
WHAT TO DO
• Ensure that the crisper is not over packed.
• Adjust crisper humidity slides.
• If crisper bin interferes with the door bins, remove door bins
before removing crisper.
• Position cabinet so that the door can be fully opened.
• Adjust temperature to a warmer setting.
WHAT TO DO
• Ensure that the cord is plugged into a live power outlet and
outlet is switched on.
• Ensure that the household circuit breaker has not tripped or that
the fuse has not blown.
• The appliance maybe in defrost mode, check again in half an
hour.
• Ensure that the doors are not held open.
• Check that large amounts of warm food have not just been
placed inside the appliance.
• Note that the appliance will run more than normal just after you
install it or when adjusting the temperature setting changes.