Table of Contents
Advertisement
Installing your new appliance.
The appliance should
arrive with the front
adjustable rollers wound
down to tilt the top of
the appliance backwards
by about 10-15mm from
upright (See Diagram 1).
The stability foot should
also be wound fully up
so it will not interfere
with the operation of the
rollers (See Diagram 2).
1. Roll the appliance into
its final position.
WARNING: The rollers are designed for forward or
backward movement only. They are not castors. Moving
the appliance sideways may damage your floor and the
rollers.
2. The top of the appliance should be tilted back by
approximately 10-15mm. This will allow the doors to self-
close providing a consistent door seal. (See Diagram 1)
Diagram 2
3. If the appliance is not tilted back, you can adjust the
two front rollers by turning the large, plastic roller nut (See
Diagram 2). This will increase the height of the rollers. One
turn of the nut will tilt the appliance back approximately
10mm. If you have difficulty turning the roller nut you can
have someone tilt the appliance back, so that you have
better access. Alternatively, you can access the rollers from
the side, using a flat screwdriver to help you turn the nut
(see Diagram 2).
Diagram 3
4. Check the alignment of the appliance to the surrounding
cupboards. The top of the appliance should be level from
side to side (see Diagram 3). If you need to adjust the level,
use the adjustable rollers as discussed in Step 3.
3 - Installation
5. If the appliance now rocks from one corner to the
opposite rear corner, this means that the floor is uneven;
you will need to put some packing under one of the rear
rollers.You could use thin pieces of solid material, such as
thin board, vinyl floor tiles or laminate. Place the packing
so that it will sit under one of the rear rollers when the
appliance is rolled into position.
6. On certain floor surfaces the appliance mayroll forward
during operation. Where provided a "Roller Stop" can be
placed under the front rollers. Refer diagram 4.
Diagram 1
7. You may now need to fine-tune the installation by
repeating Steps 3, 4 and 5.
8. When you have the appliance in final position wind the
stabilising foot down until it just makes contact with the
floor (see Diagram 5). Whenever you need to move the
appliance, be sure to wind the foot back up so that the
appliance can roll freely.
9. Clean your appliance thoroughly following the
instructions on page 12 and wipe off any dust that has
accumulated during shipping.
10. Plug the appliance into the power point. Don't use
a double adaptor. If you need to roll the appliance
out to get at the power point, remember to raise the
stabilizing foot before you do so.
11. We recommend that you let your appliance run for two
to three hours before you put any food in it. This will allow
you to check that it is operating properly
Congratulations! You have successfully installed your
new all refrigerator or vertical freezer.
Page 6
Roller Stop
Diagram 4
Diagram 5
Advertisement
Table of Contents
