Table of Contents
Advertisement
Important:
As a safety measure, before you start cleaning the cooker be sure to disconnect it from the
mains supply.
Cleaning the hob
Spillage on the hob can usually be removed by a damp soapy cloth. More obstinate stains
can be removed by rubbing gently with a soapy scouring pad or mild household cleaner.
Black burners ("oxi-black" coating)
They can be removed and washed only with soapy water.
Detergents can be used but must not be abrasive or corrosive.
Do not use abrasive sponges or pads.
Do not put in dishwasher.
After each cleaning, make sure that the burner-caps, as well as the burners, have been well
wiped off and CORRECTLY POSITIONED.
It is essential to check the correct position of the burner-caps as the least displacement from
the housing may cause serious problems.
Gas taps
If a tap becomes stiff, do not force; contact your local COMET Service Centre.
(See enclosed Service Information).
Flexible tube
From time to time, check the flexible tube connecting the gas supply to the cooker.
It must be always in perfect condition; in case of damage arrange for it to be replaced by a
C.O.R.G.I. registered installer.
Cleaning oven parts after use
The oven interior and the chromium plated shelves can be cleaned by damp soapy cloth.
Obstinate stains can be removed with nylon scouring pads and gentle, non-abrasive, liquid
cleaner. Provided the oven is wiped over immediately after roasting, only the minimum of
cleaning should be necessary.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Stainless steel surfaces
The stainless steel front panels on this cooker (facia, oven door, drawer or storage
compartment) are protected by a finger-print proof lacquer. To avoid damaging this
lacquer, do not clean the stainless steel with abrasive cleaners or abrasive cloths or scouring
pads.
ONLY SOAP/WARM WATER MUST BE USED TO CLEAN THE STAINLESS STEEL SURFACES.
Care and maintenance
15
Advertisement
Table of Contents
