Advertisement
This remote has the ability to operate 2 similar Alarms From A Single Transmitter. To toggle on
and off vehicle one or two,,,
Press the Trunk/Key button + the Lock button for 5 seconds.
The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode.
Program this transmitter into the second vehicle's system. Any time you are in 2nd vehicle mode
when the transmitter is operated, the LED will flash twice for each function. When in the prime
vehicle mode, the LED will flash once for each function.
To Erase All Transmitters:
1) Turn the ignition switch to the "On" position.
2) Press and release the pushbutton switch found on the windshield mount receiver 3 times.
(The LED on the receiver will flash.
3) Press and hold the push-button switch on the windshield receiver for 6 seconds. The LED
will flash 2X fast which is an indication all transmitters programmed to the system are now
erased.
4) Turn the ignition switch off.
Once you have erased all transmitters, you will have to go back and program all transmitters
that you want to operate your system.
Transmitter Battery Replacement
1) Remove the 00 Phillips head screw from the rear case.
2) Separate the case halves by inserting a small plastic tool in the top right slot.
3) Carefully slide the CR2032 battery out from under the battery clip and dispose of properly.
4) Insert a fresh CR2032 battery with the (+) side up away from the PCB.
5) Close the case in reverse order of disassembly
.
Page 6
128-9450
Page 6
Advertisement
