Advertisement
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run for the preprogrammed time
(5, to 60 minutes), and then shut off. This will continue for 48 hours.
NOTE: The automatic start up timer can also be initiated from the keychain transmitter. To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the second channel
transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the second channel
transmitter button 2 times.
3.Within 10 seconds of step 2, activate the RF start command two times
(Push the second channel button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.
CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal.
2. Remote start the vehicle using your keychain RF transmitter.
Programming New Or Replacement 145SP Transmitters.
1) Turn the ignition key to the on position
2) Press and release the valet/programming switch found on the windshield receiver 3 times.
3) Press the Lock Button of each transmitter you want programmed until the lights flash or you hear
a chirp from the horn or siren.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, buttons which are typical for most systems.
For additional channel programming beyond the option 1, option 2, etc,,,you can use any unused
button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the following:
From step 3 above:
a) Press and release the valet/programming button 3 additional times to get to channel 4, then
Press any unused transmitter button or button combination to program channel 4.
b) From a, press and release the valet/programming button 1 time to get to channel 5, then press
any unused transmitter button or button combination to program channel 5
c) From b, press and release the valet/programming button 1 time to get to channel 6, then press
any unused transmitter button or button combination to program channel 6 .
d) From c press and release the valet/programming button 1 time to get to channel 7, then press
any unused transmitter button or button combination to program channel 7
Note: Not all systems have channels above 3, check with your installation center for options your
system may or may not have.
Note: Certain systems have the ability to utilize channels 6 and 7 for driver priority programming.
For driver priority, the vehicle must be equipped with this feature, and the optional feature must be
set up and installed by your installation center. Once this feature is added when the unlock button
of transmitter 1 is used, it will set driver 1 priority and when the unlock button of transmitter 2 is
used it will set driver 2 priority. In this situation, the unlock button can be programmed into two
receiver channels, unlock, channel 2 and driver priority 6 or 7. In no other circumstance will the
system allow a transmitter button to be programmed into 2 receiver channels at the same time.
Page 5
128-9450
Page 5
Advertisement
