Advertisement
Quick Stop Mode:
With vehicle running, if you wish to make a quick stop and leave the vehicle running, once you
arrive at your destination:
a) Place the gear selector in Park,
b) Set the parking brake,
c) With your foot OFF the brake, press the transmitter button two times in succession.
The vehicle will now be under control of the remote start system. Turn your ignition switch off,
WITHOUT, stepping on the brake, and exit the vehicle. Lock the doors with the key to insure
security.
(Alarm Systems Only) PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily bypass all alarm
functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics.
When the system is in valet mode, all alarm functions are bypassed, however the remote panic
feature and remote door locks will remain operational. To use the valet mode, the system must
first be disarmed either by using your keychain transmitter, or by activating your personalized
manual override code.
1. Enter the vehicle, and turn the ignition key to the on position.
2. Press and hold the Push-Button switch until the LED turns on solid. The system will remain in
the valet mode.
3. To return to normal operation, press and release the Push-Button switch any time the ignition is
on.
NOTE: Always remember to return the vehicle to the valet off position. This will ensure that the
vehicle remains protected at all times.
(Alarm Systems Only) MANUALLY OVERRIDING YOUR SYSTEM:
USING THE RECEIVERS PUSH-BUTTON OVERRIDE SWITCH
Your Security System can be disarmed without the use of the keychain transmitter. This is necessary,
since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. If
your system has been selected for Valet Switch manual override as indicated on the last page of
this manual, to bypass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and release the push-button override switch.
The alarm system will stop sounding and enter the (bypassed) mode. You can now start and
operate the vehicle normally.
Typically this override mode is used only if the transmitter has become inoperative.
(Alarm & Keyless Systems Only) PROGRAMMING YOUR CUSTOM OVERRIDE CODE
Unlike override switches easily found, and defeated, this security system allows the consumer to
program a personal override code, offering a higher level of security. To take advantage of this option,
programmable feature # 9 must be selected for the Custom Code Option. Consult your installation
center for programming details. The system comes from the factory with a preprogrammed override
code of 11. To change this default override code, do the following:
1. Disarm the system by use of the transmitter, or by use of the emergency override sequence.
Turn the ignition switch to the on position.
2. Within 10 seconds, press and release the Receivers push-button switch, 3 times.
3. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep
and the lights will flash one time.)
4. Within 10 seconds, begin to enter your chosen 10ths digit by pressing and releasing the Receivers
push-button switch from 1 up to 9 times.
5. Within 10 seconds of the last entered 10ths digit, turn the ignition switch off then on.
Page 2
128-9450
Page 2
Advertisement
