INTRODUCTION Thank you for purchasing this CLARKE portable worklight. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved BS 1363 plug, or a suitably fused isolator switch. If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below.
SAFETY PRECAUTIONS 1. This worklight must not be immersed in water. 2. DO NOT look directly into the lamp when switched on as this can damage the eyes. 3. DO NOT use this worklight if it has a damaged lens, casing or supply cable. 4.
9. DO NOT attempt to repair or modify this product or attempt any electrical repair yourself. Consult the CLARKE Service Department. ENVIRONMENTAL RECYCLING POLICY Through purchase of this product, the customer is taking on the obligation to deal with the WEEE in accordance with the WEEE regulations in relation to the treatment, recycling &...
COMPONENT PARTS Face frame Angle adjusting knob M6 Tempered glass 4mm Stand locking knob M6 Reflector Stand Screw M3 x 6 Carrying handle LED panel O-ring Aluminium housing Waterproof end cap Connecting sleeve Waterproof cable gland Washer M6 Power cable with plug Parts &...
Need help?
Do you have a question about the SMD2700L and is the answer not in the manual?
Questions and answers