Table of Contents
Advertisement
Maintenance
item No.
Checking DP operation
U203
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the item to be operated.
Display
CCD ADP
(NON P)
CCD ADP
CCD RADP
(NON P)
CCD RADP
SPEED
4. Press the start key. The operation starts.
5. To stop continuous operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the presence or absence of a key card or key counter
U204
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
To run this maintenance item if a key card or key counter is installed.
Method
1. Press the start key.
2. Select the item to be set. The setting screen for the selected item is displayed.
Display
KEY-DEVICE
MESSAGE
Setting: [KEY-DEVICE]
1. Select the optional counter to be installed.
Display
KEY-CARD
KEY-COUNTER
OFF
Initial setting: OFF
2. Press the start key. The setting is set.
3. Turn the main power switch off and on.
Setting: [MESSAGE]
1. Select the [KEY-DEVICE] or [COIN VENDOR].
2. Press the start key. The setting is set.
3. Turn the main power switch off and on.
Y112040-6
Description
Description
Without paper, single-sided original
(continuous operation)
With paper, single-sided original
Without paper, double-sided original
(continuous operation)
With paper, double-sided original
Switching between normal reading (600 dpi)
and high-speed reading
Description
Sets the presence or absence of the key card or key counter
Sets the message when optional equipment is not installed
Description
The key card is installed
The key counter is installed
Not installed
Service Manual
Setting range
Initial setting
-
-
-
-
-
-
-
-
0 (Normal)/
0
1 (High-speed)
2K5
1-3-55
Advertisement
Table of Contents
