One Class 1 PD device and One Class 2 PD device
CAUTION: You must use only a power supply that is provided or approved by HP for
use with this NJ1000G. Failure to comply with this requirement may result in damage
to the NJ1000G, or may result in a hazardous situation or personal injury.
3. Plan the Installation
When installed, the back of the NJ1000G extends into a wall for 0.5 inches.
Because the depth of some wall openings differs, observe the following
requirements and recommendations before you install the NJ1000G:
Make sure that the wall opening where the NJ1000G is being installed
complies with the NEMA-WD6 standard, as described in this diagram:
Make sure that the distance between the back of the NJ1000G and the inside
of the wall is at least 1.5 inches (3 inches is recommended).
1.750"
(44.45mm)
2.8125"
(71.44 mm)
Screw holes
9
3.28125"
(83.31mm)
reference