Table of Contents
Advertisement
Installing Memory Modules
This mainboard accommodates 184-pin 2.5V unbuffered Double Data Rate
(DDR) SDRAM memory modules. The memory bus runs at 133 MHz.
The mainboard accommodates three memory modules. You must install at
least one module in any of the three slots. Each module can be installed with
32 MB to 1 GB of memory; total memory capacity is 3 GB.
Do not remove any memory module from its antistatic packaging until
you are ready to install it on the mainboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear
a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1.
This mainboard supports unbuffered DDR SDRAM only. Do not attempt to
insert any other type of DDR SDRAM into the slots.
2.
Push the latches on each side of the DIMM slot down.
3.
Align the memory module with
the slot. The DIMM slots are
keyed with notches and the
DIMMs are keyed with cutouts
so that they can only be in-
stalled correctly.
4.
Check that the cutouts on the
DIMM module edge connector
match the notches in the
DIMM slot.
5.
Install the DIMM module into
the slot and press it firmly
down until it seats correctly.
The slot latches are levered
upwards and latch on to the
edges of the DIMM.
6.
Install any remaining DIMM modules.
16
Advertisement
Table of Contents
