Table of Contents
Advertisement
Adjusting the TV-UC253-V driver properties
Communication Status
Diagnostic Reporting is not applicable to the TV-UC253-V.
Protocol Status shows the status of the protocols currently running on the TV-UC253-V.
Standalone Controller Detection
You can use the fields on this page with a binary input in your control program to detect when the controller does
not receive a write request from the selected network within the specified amount of time. The input remains OFF
as long as write requests are received, but switches to ON if the controller does not receive a request within the
specified time. The binary input must have the Expander number and Input number set to 99 and the I/O Type set
to Special.
Flow Calibration Archive
NOTE This driver property only applies to controllers with built-in airflow sensors.
The Flow Calibration Archive page shows measured flow and sensor readings that were entered in the i-Vu® Test
and Balance tool or through the stand-alone Test & Balance Utility.
TruVu™ UC253-V
Installation and Start-up Guide
40
©2022 Carrier.
All rights reserved.
Advertisement
Table of Contents
Troubleshooting
