Connecting Video Source Devices - Vivitek DS272 Series User Manual

Connecting Video Source Devices

• Using an HDMI cable
1. Take an HDMI cable and connect one end to the HDMI-1/HDMI-2 jack of the com-
puter.
2. Connect the other end of the cable to the HDMI jack on the projector.
• Using a VGA (D-Sub) to HDTV (RCA) cable
1. Take a VGA (D-Sub) to HDTV (RCA) cable and connect the end with 3 RCA type
connectors to the Component Video output sockets of the Video source device.
Match the color of the plugs to the color of the sockets; green to green, blue to
blue, and red to red.
2. Connect the other end of the cable (with a D-Sub type connector) to the PC 1/PC
2 socket on the projector.
• Connecting an S-Video/composite source device
1. Take an S-Video/Video cable and connect one end to the S-Video/Video output
jack of the Video source device.
2. Connect the other end of the S-Video/Video cable to the S-VIDEO/ VIDEO jack on
the projector.
Important
•
If the selected video image is not displayed after the projector is turned on and the
correct video source has been selected, check that the Video source device is turned on
and operating correctly. Also check that the signal cables have been connected
correctly.
http://www.pureglare.com.au
13