Remove The Upper Case; Disassemble The Lcd Unit - Lenovo S14 Gen 3 Hardware Maintenance Manual

Remove the upper case

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 34
"Remove the battery pack" on page 35
"Remove the solid-state drive (SSD) module" on page 36
"Remove the Wi-Fi card" on page 37
"Remove the CMOS battery" on page 38
"Remove the memory module" on page 39
"Remove the heat sink (for Lenovo S14 G3 IAP)" on page 41
"Remove the heat sink (for Lenovo S14 G3 ABA)" on page 42
"Remove the fan" on page 42
"Remove the I/O board module" on page 43
"Remove the fingerprint board module" on page 44
"Remove the system board and the touchpad board cable" on page 46
"Remove the LCD unit" on page 49
Go to
https://support.lenovo.com/partslookup
part:
Upper case

Disassemble the LCD unit

The LCD unit as a whole is not an FRU. Instead, it contains FRUs as its components. Before disassembling
the LCD unit, make sure it has been detached from the upper case.
Remove the LCD bezel
Make sure the following FRU (CRU) has been removed.
"Remove the LCD unit" on page 49
Step 1. Remove the LCD bezel.
Figure 34. Remove the LCD bezel
Go to https://support.lenovo.com/partslookup
part:
50
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement