Remove The Lcd Unit - Lenovo S14 Gen 3 Hardware Maintenance Manual

Remove the LCD unit

Make sure the following FRUs (CRUs) has been removed.
"Remove the lower case" on page 34
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Detach the main and auxiliary antenna cable connectors and disconnect the EDP cable from the
system board. Release the antenna cables from the cable guide.
Figure 32. Detach the main and auxiliary antenna cable connectors and disconnect the EDP cable from the
system board
Step 3. Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD unit.
Figure 33. Remove four screws and then remove the LCD unit
Screw specifications
M2.5 x L5
Number of screws
4
.
Chapter 4 Removing a FRU or CRU
49