Remove the heat sink (for Lenovo S15 G3 IAP)
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 55
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Loosen six screws and then remove the heat sink.
Figure 56. Loosen six screws and then remove the heat sink
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the heat sink (for Lenovo S15 G3 ABA)
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 55
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Loosen four screws and then remove the heat sink.
62
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement