Remove the heat sink (for Lenovo S14 G3 ABA)
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 34
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Loosen four screws and then remove the heat sink.
Figure 21. Loosen four screws and then remove the heat sink
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the fan
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 34
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the fan cable from the system board and then release the antenna cables from the
cable guide. Remove three screws and then remove the fan.
42
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement