Remove the LCD unit
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 55
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Detach the main and auxiliary antenna cable connectors and disconnect the EDP cable from the
system board. Release the antenna cables from the cable guide.
Figure 69. Detach the main and auxiliary antenna cable connectors and disconnect the EDP cable from the
system board
Step 3.
Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove five screws and then remove the LCD unit.
Figure 70. Remove five screws and then remove the LCD unit
70
Hardware Maintenance Manual