Victron energy BlueSolar MPPT 75/10 Manual page 34

MPPT solar charger manual
• Select a device that needs to be removed from the VE.Direct network.
• Navigate to the settings page by clicking the gear symbol.
• Click on "VE.Smart Networking".
• Click on "leave network".
Check the network
Once the network has been set up all devices communicate with each other. The active LED on each connected device will now
blink every 4 seconds. This is an indication that the device is actively communicating with the network.
To check if an individual device is communicating with the network, click on the VE.Smart symbol in the main screen next to
the solar dail. A pop-up window will open showing the connection status and the shared parameters.
VE.Smart Networking pop-up
To check if all devices are actively communicating with the same VE.Smart Networking, navigate to the settings page of one of
the networked devices and click on "VE.Smart Networking". A screen will be shown containing which device parameters of this
device are shared and all the other devices that are connected to the same network are shown.
Example of a VE.Smart Network
More information
Page 30 Configuration and settings