Setting The Date And Time - Omron HEM-7320T-CA Instruction Manual

2. Preparation
Open the rear cover page to read the following:
The letter identifiers on the rear cover page correspond to those in the body of this page.

2.2 Setting the Date and Time

Set the monitor to the correct date and time before taking a measurement for the first time.
1.
Press the
The year flashes on the
2.
Push or button to change the year.
Push
steps to change the month, day, hour, and minute.
Year
Change
: Forward
: Back
3.
Press the START/STOP button to turn the monitor off.
Notes:
• If the batteries have been replaced, the date and time setting will need to be reset.
8
• If the date and time are not set, "-/ - -:--" appears during or after measurement.
Date/Time setting (
C
W
Date/Time display.
button to confirm the year and then the month flashes. Repeat the same
Month
Confirm
Change Confirm
) button twice.
Day
Hour
Change Confirm
Change
Minute
Confirm
Change Confirm