Standard 4 bike hitch mount rack, tiltable foldable bicycle carrier 2-inch receiver black, standard 4 bike hitch mount rack, tiltable foldable bicycle carrier 2-inch receiver black (2 pages)
INSTALLATION STEPS STEP 1: I,J,H Two pieces of K are loaded into the inside of A in advance. (The two cylinders of K are inserted into the two small holes). Insert B into the interior of A and then connect in order with I-J-H fasteners. STEP 2: STEP 3: S,T,U...
STEP 4: STEP 5: Insert the G1 and G2 components into the upper square opening of the assembled bike frame B and position the Insert the V at the place marked by the arrow sliding position with the keys X carried on the G1,G2 above, and tighten it with a screwdriver.
Page 5
TIGHTEN THE HANDLE •Hold with your left hand and pull it outward slightly. •Squeeze tightly with the right hand and tighten. •Loosen •Pull out and rotate •Insert and rotate the handle clockwise until tightened. •Pull out with force and rotate back to the initial state to tighten again.
Page 6
STEP 3: STEP 4: T-pull handle Cube then fold and collect the T-pull after releasing it.And Pull up the handle to fold up when not carrying bikes. the sheet metal slot for positioning. RACK TILT STEPS T-pull handle Pull out the T-handle and put it down.
Page 7
1. When the vehicle is equipped with an electric to the market. rear fender, the power must be turned off when 2.While the FORWODE bike carrier design team strives installing the rear carrier. If this option is not to make most products universal to the cars on the available, do not use the rear bike carrier.
Need help?
Do you have a question about the DB-HBS42 and is the answer not in the manual?
Questions and answers