Analog Av Connections; Using The Back Analog Video / Audio Input Jack To Connect A Vcr (Or Other Analog Device); Connecting Analog Audio Out Jacks To A Stereo Amplifier - Sanyo HT27546 Owner's Manual

USING THE BACK VIDEO AND AUDIO
INPUT JACKS TO CONNECT A VCR
(OR OTHER ANALOG DEVICE)
Switch off DTV and external equipment before connect-
ing cables. (Cables are not supplied.)
1
Connect VCR's Audio Video Out to the DTV's
VIDEO2 Video In jacks.
NOTE: For Mono VCR (Single Audio Jack), connect VCR
Audio Out to DTV Audio (L) Input.
2 2
Optional
Connect VCR's S-Video Out to the DTV's S-Video In
Jack.
NOTE: S-Video jack connection overrides Video jack con-
nection (VIDEO2).
3
Press POWER to turn on the DTV, then turn on
external equipment.
4
Press INPUT to select Video2 to
view the VCR program.
BACK VIEW
OF VCR
1
DTV VIDEO2
AV INPUT
JACKS
REMOTE CONTROL
INPUT
POWER
1 2 3
4
4 5 6
3
10
Need help?
Visit our Web site at

ANALOG AV CONNECTIONS

S-VIDEO
JACK
2 2
What you will need for connections:
Audio Video Cable – 1
S-Video Cable – 1
www.sanyoctv.com
CONNECTING ANALOG AUDIO OUT
JACKS TO A STEREO AMPLIFIER
Switch off DTV and external equipment before connect-
ing cables. (Cables are not supplied.)
1
Connect the DTV Audio Out (L /R) to the Stereo
Amplifier In (L/R).
2
Press POWER to turn on the DTV, then turn on
external equipment.
NOTE: Do not connect external speakers directly to the DTV.
2
STEREO AMPLIFIER
IMPORTANT NOTE FOR MONITOR USE:
If you did not connect an antenna, you must run All
Channel Search twice before you can select the AV inputs.
I
"No Signal" will appear randomly on the screen when no signal is
detected at the VIDEO2 input jack.
I
Press the INPUT key after connecting cables to access the AV
inputs. There is NO need to tune to a blank channel.
I
Position your DTV at least 2 feet from stereo speakers. The magnets
in the speakers may affect the picture quality.
1-800-877-5032
or Call
1
BACK VIEW
OF DTV
REMOTE CONTROL
INPUT
POWER
1 2
4 5
3
2
6