Martin EC Series Installation Manual

EC Series Curving Kit
Installation Guide
WARNING! Before installing an EC Series™ Curving Kit, Read "Safety Information" on page 3 of the EC
Series Safety and Installation Guide supplied with EC Series flightcases and available for download
free of charge from the Support pages for the products in the EC Series on www.martin.com.
WARNING! The safety and suitability of lifting equipment, installation location, anchoring method,
mounting hardware, suspension structures and electrical installation is the responsibility of the
installer. All local safety regulations and legal requirements must be observed when installing and
connecting the EC Series Headers.
WARNING! Installation must be carried out by qualified professionals only. Contact your Martin™
supplier for assistance if you have any questions about how to install this product safely.
EC Series Headers and panels can be attached horizontally at up to +/- 20° angles to form a convex or concave
wall using the EC Series Curving Kit (P/N 90354270).
Unpacking
The EC Series Curving Kit is supplied in a cardboard box. Curving Kit components can be stored in an EC
Series 8-unit Flightcase. Each kit contains:
• 50 x EC Series Curving Plate Locking Thumbwheels
• 50 x locknuts for thumbwheels
• 25 x EC Series Curving Plates ('Bananas')
• 1 x EC Series Curving Kit Installation & Safety Guide
Side-to-side attachment in a curved wall
To install panels in a curved configuration:
1. See Figure 1. Unscrew the 2.5 mm Allen bolts shown and
remove the straight side-to-side alignment cones B and
washers A close to the top and to the bottom of one side of
each panel. Store all components for possible re-use.
2. Remove the similar alignment cones from the Headers.
3. Suspend the panels vertically as described in the EC Series
user manual.
©2010-2011 Martin Professional A/S. Information subject to change without notice. Martin Professional A/S and all affiliated companies disclaim liability
for any injury, damage, direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to use or reliance on
the information contained in this manual. The Martin logo, the Martin name and all other trademarks in this document pertaining to services or products
by Martin Professional A/S or its affiliates and subsidiaries are trademarks owned or licensed by Martin Professional A/S or its affiliates or subsidiaries.
P/N 35000612, Rev. E
Figure 1: Removing side-to-side
alignment cones