Table of Contents
Advertisement
Press and hold the
0
button until
2.
display.
Press the
button repeatedly until
0
3.
hardness range "medium").
Turn the rotary selector to change the water hardness range.
4.
Possible values:
softened
™† ‹
soft
™† ‚
medium
™† ƒ
hard
™† „
very hard
™† ...
Press and hold the
button to exit basic settings.
0
5.
The change is saved.
Operating the appliance
In this section, you can read about
how to fill the water tank
■
how to switch the appliance on and off
■
what to note after each use
■
how to change the clock time
■
Filling the water tank
Press the
symbol to open the appliance door. You can see
w
the water tank on the right.
Caution!
Use of unsuitable liquids may damage the appliance
Only use fresh tap water, softened water or uncarbonated
■
mineral water.
If your tap water is very hard, we recommend that you use
■
softened water.
Do not use distilled water, highly chlorinated tap water
■
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
Fill the water tank before each use:
Open the appliance door and remove the water tank (fig. A).
1.
Fill the water tank with cold water (fig. B).
2.
MIN
Amount of water required for approx. 30 minutes
steaming at 100 °C
MAX
Amount of water required for approx. 2 hours
steaming at 100 °C
™‚ ‚
appears in the
appears (water
™† ƒ
-
I
II
II
IV
First use
Before first use, heat the empty appliance for 20 minutes at
100 °C. Do not open the appliance door during this time. The
appliance is automatically calibrated (see section: Automatic
calibration).
Press the
#
button to switch on the appliance.
1.
Fill the water tank and insert it (see section: Filling the
2.
water tank).
Press the
button.
J
3.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation ends automatically and an audible
signal sounds.
Press the
button to switch off the appliance.
#
4.
Leave the appliance door ajar until the appliance has cooled
down.
Cleaning the accessories before use
Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
$
Slide the water tank in fully (as far as it will go), and press it in
3.
using the textured area at the bottom (fig. C).
&
The tank must be flush with the water tank recess (fig. D).
%
0 $ ;
'
7
Advertisement
Table of Contents
