Table of Contents
Advertisement
en Before using for the first time
Combining accessories
You can combine the wire rack with the universal pan
to catch any liquid that drips down.
Place the wire rack on the universal pan so that
1.
both spacers
are on the rear edge of the univer-
sal pan.
Insert the universal pan between the two guide rods
2.
for a shelf position. In so doing, the wire rack is on
top of the upper guide rod.
Wire rack
on univer-
sal pan
Before using for the first time
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Performing initial start-up
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up. It
may take a few minutes for the settings to appear on
the display.
Note: You can also use the Home Connect app to con-
figure the settings. When your appliance is connected,
follow the instructions in the app.
Press
to switch the appliance on.
1.
a The first setting appears.
If required, change the setting.
2.
Possible settings:
– Language
– Home Connect
– Time
– Date
Use
to switch to the next setting.
3.
Work through the settings and make changes as re-
4.
quired.
a After the last setting, a message appears on the dis-
play confirming that the initial start-up is complete.
To check the appliance before heating for the first
5.
time, open and close the appliance door once.
Basic operation
8 Basic operation
8.1 Switching on the appliance
Press
to switch the appliance on.
▶
a The display shows the menu.
10
6.3 Other accessories
You can purchase other accessories from our cus-
tomer service, specialist retailers or online.
You will find a comprehensive range of products for
your appliance in our brochures and online:
siemens-home.bsh-group.com
Accessories are appliance-specific. When purchasing
accessories, always quote the exact product number (E
no.) of your appliance.
You can find out which accessories are available for
your appliance in our online shop or from our customer
service.
7.2 Cleaning the appliance before using it
for the first time
Before using the appliance to cook food for the first
time, you must clean the cooking compartment and ac-
cessories.
Remove the product information and the accessor-
1.
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
any adhesive tape either in or on the appliance.
Wipe the smooth surfaces in the cooking compart-
2.
ment with a soft, damp cloth.
Press
to switch the appliance on.
3.
Apply the following settings:
4.
Type of heating
Temperature
Cooking time
→ "Basic operation", Page 10
Start the operation.
5.
Ventilate the kitchen while the appliance is heat-
‒
ing.
a Once the cooking time has elapsed, a signal tone
sounds. A note appears on the display confirming
that the operation has finished.
Press
to switch the appliance off.
6.
Once the appliance has cooled down, clean the
7.
smooth surfaces in the cooking compartment with a
detergent solution and a dish cloth.
Clean the accessories thoroughly using a detergent
8.
solution and a dish cloth or soft brush.
8.2 Switching off the appliance
Switch your appliance off when you are not using it.
The appliance automatically switches itself off if it is not
used for a certain period of time.
Press
to switch the appliance off.
▶
3D hot air
Maximum
1 hour
Advertisement
Table of Contents
