Hilti DX 9-HSN Manual page 23

Trouble or fault
No fastener is driven.
The tool cannot be pressed
fully against the working sur-
face.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 28.06.2017 | Doc-Nr: PUB / 5359689 / 000 / 00
Possible cause
The fastener guide is clogged with
dirt.
A fastener is jammed in the fas-
tener guide.
The rotating sleeve is not fully
closed.
The nail detector is jammed.
Part of the nail detector is broken.
Action to be taken
▶ Clean the base plate and
the parts attached to it using
the brushes intended for this
purpose.
▶ Remove the jammed fastener.
▶ Avoid shear breakage. Avoid
missing the beam. It may be
necessary to mark the position
of the beam better in future.
▶ Close the rotating sleeve.
→ page 8
▶ Clean the base plate and
remove all foreign objects.
Take care to ensure adequate
lubrication of the fastener strip
guides with Hilti lubricant spray.
▶ Check for correct operation of
the nail detector by checking
that the tool is ready for use
→ page 6.
English 15