Hilti DX 9-HSN Manual page 13

Information shown in the middle of the display
Display
Information shown in the lower part of the display
Display
3.7 Items supplied
Fastening tool, toolbox, cleaning set, scraper, ramrod, Hilti lubricant spray, operating instructions.
Note
You can find other system products approved for use with this product at your local Hilti Center or
online at: www.hilti.com
4 Technical data
4.1 Technical data
Weight
Dimensions (L × W × H)
Magazine capacity
Printed: 28.06.2017 | Doc-Nr: PUB / 5359689 / 000 / 00
Explanation
The tool temperature is shown in the middle of the display.
In this case the tool temperature is within the normal range.
The temperature of the tool is extremely high. A warning symbol
indicates that use of the tool should not be interrupted when the
tool reaches this temperature as cartridges may ignite prematurely
and the plastic nail strip may melt. We therefore recommend that the
tool continues to be used, but at a lower fastening rate, so that the
temperature of the tool can return to normal.
Important:
The cartridge strip and the fastener strip must be removed from
the tool immediately if use of the tool is interrupted while a warning
symbol is displayed.
Explanation
At the lower left edge, a bar showing 1 to 7 segments indicates the
interval until the tool needs to be cleaned again.
In this case, cleaning will not be necessary for some time.
The 7 segments shown indicate that cleaning will be necessary
shortly.
The max. number of fasteners driven has been reached. The tool must
be cleaned.
The black square at the lower edge on the right indicates that demo
mode is active. In this case, the information in the display does not
reflect the actual status of the tool.
The Hilti Connect smartphone app can be used to deactivate the
demo mode. Demo mode is automatically deactivated after a period of
15 minutes.
DX 9–HSN
30.0 lb
(13.6 kg)
39.3 in × 17.5 in × 7.4 in
(999 mm × 445 mm × 188 mm)
60 nails / 40 cartridges
English 5