Hilti DX 9-HSN Manual page 14

Suitable cartridges
Suitable fasteners
Thickness of the supporting steel
Compression stroke
Contact pressure
Application temperature (ambient tem-
perature)
4.2 Noise information
The noise values listed were determined under the following conditions:
General conditions for noise measurements
Direct fastening tool
Model
Caliber
Power setting
Application
Noise information in accordance with EN 15895
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Peak sound pressure emission level (L
Uncertainty for the peak sound pressure level (K
4.3 Vibration
The vibration value that must be specified in accordance with 2006/42/EC does not exceed 2,5 m/s².
5 Operation
5.1 Preparations at the workplace
5.1.1 Establishing the position of the fasteners
To avoid incorrectly driven fasteners, proceed as follows:
▶ Each time you lay a metal sheet in position on the steel beams, use a water-resistant pen to mark the
area in which fasteners can be driven.
Note
Do this each time, for each individual metal sheet. It is not sufficient to simply mark the ends of
the beam and then draw a straight line between these points as the supporting beams may be
distorted, i.e. curved.
5.1.2 Checking that the tool is ready for use
Note
This check should always be carried out immediately before use of the fastening tool and after
reassembling the tool after cleaning or after a routine check of the condition of the piston and piston
brake.
6 English
Printed: 28.06.2017 | Doc-Nr: PUB / 5359689 / 000 / 00
DX 9–HSN
6.8/11 M40 red or other cartridges of a type approved for use
with the tool
X­HSN 24
1/8 ... 3/8"
3.5 in
(89 mm)
≥ 81 lb
f
(≥ 360 N)
5 ℉ ... 122 ℉
(−15 ℃ ... 50 ℃)
DX 9–HSN
Series
6.8/11 red
4
Fastening to steel plate (Brinell hardness 358 N/mm
X–HSN 24
)
pA
)
pA
)
)
WA
)
pC, peak
98 dB(A)
2 dB(A)
106 dB(A)
2 dB(A)
131 dB(C)
) 2 dB(C)
pCpeak
) using the
2