Nikon D7000 Repair Manual page 159

VBA29001-R.3814.A
・ Tip.section's.width.of.the.tool,.appropriate.to.the.showing.value.of.adj..software
Temporary standard in case the reference is 2.8 mm (0μm)
-60μm -30μm 0μm +30μm +60μm
Showing.val..of.adj...software
Tip.section's.width.of.tool 2.6 mm
2.7mm 2.8mm 2.9mm 3.0mm
※ As for some bodies, the reference (0μm) is not 2.8 mm, so this is just tentative criteria for judgement.
e.g. In case the value of the adjustment software shows "-60μm":.
Use the tool with 2.6 mm in the width. (Narrow the gap.）
e.g. In case the value of the adjustment software shows "+60μm": .
......Use.the.tool.with.3.0.mm.in.the.width...（Widen.the.gap.）
- A92 ・ D7000 -
NICS