Disposal Instruction ....12 Introduction ECtemp 531 is an electronic thermostat provided with a 2-pole switch and a room sensor to measure and control the desired air temperature.
Danfoss ECtemp 531 Technical Specifications Operation voltage 220-240 V~, 50 Hz Standby power consump- Max 0.25 W tion Relay: Resistive load Max 15 A / 3450 W @ 230 V Inductive load cos φ= 0.3 max 1A Sensing units NTC 15kOhm at 25°C Sensing values: 0 °C...
Page 5
Danfoss ECtemp 531 Type Storage temperature -20 to +65 °C IP class Protection class Class II - Dimensions 85 x 85 x 36 mm Weight 90 g The product complies with the EN/IEC Standard “Automatic electrical controls for household and similar use”: •...
Danfoss ECtemp 531 Safety Instructions Make sure the mains supply to the thermostat is turned off before installation. IMPORTANT: When the thermostat is used to control a floor heating element in connection with a wooden floor or similar material, always use a floor sensor and never set the maximum floor temperature to more than 35°C.
Danfoss ECtemp 531 Mounting Instructions Please observe the following placement guidelines: Place the thermostat at a suitable height on the wall (typically 80-170cm.). In wet rooms, always place the thermostat according to local regulation on IP classes. Do not place the thermostat on the inner side of an exterior wall.
Page 8
Danfoss ECtemp 531 Follow the steps below to mount the thermostat: Open the thermostat: • Press the release tab in the bottom of the ther- mostat using a flat object. • Carefully detach the front cover. • Carefully detach the frame.
Page 9
Danfoss ECtemp 531 Connect the thermostat according to the connection diagram. LOAD LOAD Mains Max. Load 220-240V~ 15 (1) A IP31 -10T30 D531 The screen of the heating cable must be connected to the earth conductor of the power supply cable by using a separate connector.
All work will be invoiced in full if Danfoss is required to inspect or repair faults that have arisen as a result of any of the above. The Danfoss warranty shall not extend to products which have not been paid in full. Danfoss will, at all times, provide a rapid and effective response to all complaints and inquiries from our customers.