Table of Contents
Advertisement
Storage
1. Clean the housing and controls thoroughly prior to storage.
2. Remove the rear o-ring. Place in a small re-sealable plastic bag
inside of the housing.
3. Leave the lid snaps open to release pressure on the lid snap
springs.
4. Store the housing in a cool, dry place away from direct sunlight and
chemicals.
5. Before using the housing, check the tightness of the set screw in
each control knob. Check each control gland to make sure they are
snug. There is a slight chance that either could vibrate loose during
travel.
Do not leave the camera and housing in direct sunlight for
»
prolonged periods. Heat may damage the camera.
Do not transport with the camera inside of the housing.
»
Do not store the housing in a humid environment. Prolonged
»
exposure to high humidity may damage electronic
components.
Servicing Recommendations
It is recommended that the housing be sent to Ikelite or an authorized
service center annually for routine service and maintenance. Service
may be required more or less frequently depending on care and use.
Lubricating Controls
The housing's controls may need to be lubricated if they become
particularly difficult to use or if the o-rings have dried out during longer
periods of storage.
17
Advertisement
Table of Contents
