Lens Port; Storage - Ikelite 200DLM/D Manual

2. NEVER leave your housing in a fresh water rinse tank, even if it is
the only system in the tank. Collisions with another person's gear
can cause scratches or damage to your equipment. Accidental
damage occurs most often in the rinse tank.
3. Rinse off any residual residue from the rinse tank with clean,
running fresh water.
4. Stow the housing in a shaded place where it is protected from
impact and overheating. If no shade is available, cover the housing
with a light colored towel or cloth.
5. Check the memory card capacity and battery life of your camera
and strobe(s). Recharge as necessary.
6. Always re-check the o-ring seal after opening the housing.
Do not rinse the inside of the housing. The viewfinder and
»
hotshoe are susceptible to water damage.

Lens Port

Treat the surface of the lens port like a camera lens. After use, rinse
and gently dry the outside lens port to avoid water spotting. Use only a
microfiber lens cleaning cloth to avoid scratches. To clean, use a mild
soap solution.
Do not rinse the inside of the lens port.
»
Do not use alcohol, cleaning agents, spray lubricants, Rain-X,
»
or other solvents on the housing or lens port. Use of an
incompatible chemical compound can damage the plastic and
o-rings, and may result in leaking.

Storage

1. Clean the housing and controls thoroughly prior to storage.
2. Remove the rear o-ring. Place in a small re-sealable plastic bag
inside of the housing.
22