Control Dial; Using The Built-In Flash; Using The Flash Diffuser; Installing The Flash Diffuser - Ikelite DMC-ZS40 Instruction Manual

Control Dial

A small section of the rubber disc is missing at the end of this control.
This is normal and allows the user to completely disengage the control
from the camera when not in use.
To disengage the dial, line up the dot on the knob with the dot on the
housing back.

Using the Built-in Flash

The camera's built-in flash may be used to illuminate subjects
underwater.

Using the Flash Diffuser

Install the semi-transparent diffuser when using the camera's built-
in flash. A portion of the camera's built-in flash may be blocked by
the housing's lens port. The diffuser spreads the light of the flash to
reduce any effects on the image.
It may be necessary to zoom in when shooting close-up photos to
completely eliminate any darkened areas.

Installing the Flash Diffuser

1. The flash deflector must be removed to use the camera's built-
in flash to illuminate a photo. If a deflector is installed, lift the
bottom with your thumb or a dull instrument and pull away from
the housing. The deflector must be removed prior to inserting the
camera in the housing.
2. Press the large opening of the flash diffuser over the housing's lens
port until it snaps into the groove in the outer circumference of the
port. The piece may bend during installation.
12