Connector Board - HP ProDesk 480 G6 MT Maintenance And Service Manual

Connector board

Follow these steps to remove the connector board:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
a. Front bezel (see
b. WLAN module (see
c. Solid-state drive (see
d. Drive cage (see
e. Fan-sink (see
f. System board (see
Remove the connector board:
1. Remove the two Phillips PM2.0×3.5 screws (1) that secure the connector board to the system board.
2. Remove the connector board (2).
NOTE:
separated from the board.
Reverse this procedure to install the connector board.
Access panel on page
Front bezel on page
WLAN module on page
Solid-state drive on page
Drive cage on page
Fan-sink on page
System board on page
When the connector board is removed, make sure the connector board bracket does not become
Preparation for disassembly on page
32), and then remove the following components:
35)
41)
42)
36)
46)
49)
31).
Connector board 51