Cleaning Instruction - ESAB ET 210iP Advanced Instruction Manual

6 MAINTENANCE
6.2

Cleaning instruction

To maintain the performance and increase the lifetime of the power source it is mandatory to clean it
regularly. How often depends on:
• the welding process
• the arc time
• the working environment
CAUTION!
Make sure that the cleaning procedure is done in a suitable prepared workspace.
CAUTION!
During cleaning, always wear recommended personal safety equipment, such as ear plugs,
safety glasses, masks, gloves and safety shoes.
CAUTION!
The cleaning procedure should be carried out by authorised service technician.
1. Disconnect the power source from the mains supply.
WARNING!
Wait at least 30 seconds for the capacitors to discharge before continuing.
2. Remove the four screws holding the right side panel (R) and remove the panel.
3. Clean the right side of the power source, using dry compressed air with reduced
pressure.
NOTE!
Since the power source contains one "dirty side" (the right side) and one
"clean side" (the left side), it is important that you do not remove the left side
panel before cleaning the right side of the power source.
0463 859 001 - 35 - © ESAB AB 2023