Table of Contents
Advertisement
Setting up the massage lounger
1) Checking the accessories
●
Armrests (Right/Left) The holes in the fabric at the back of the hand & arm massage
Right/Left indication
(armrest back)
2) Where to use the unit
Ensure there is adequate space to recline.
●
Dimensions required for installation ( see page EN53 for the detailed dimensions of the main unit)
Approximate Dimension: Height 115 cm × Width 90 cm × Depth* 220 cm
* The actual depth of the main unit is 200 cm but the required depth is stated as 220 cm so as to install it at least 10 cm
away from the wall etc. at the front and back.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
This can cause discoloration or hardening of the synthetic leather.
3) Installing
Hold the legrest by the sides
EN10
section are due to the manufacturing process and are not a fault.
●
Pillow
●
Power cord
Place your fingers in
the groove
Hold the legrest with your hands until it has
been set on the floor completely.
If you release the legrest too soon, it will
spring back to the initial position.
●
Comfort cushion
①
The unit must be carried by two or
more persons.
ㅡ Since the unit is heavy, be careful to avoid
back injuries.
Unit weight
Approx. 87 kg
②
Watch your step carefully and put
down the unit slowly.
Lay out a mat etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the size
of the mat should be sufficient (at least
120 cm × 70 cm) to cover the areas where
the unit touches and where the legrest
could touch the floor.
■ Do not hold the foot part!
The sole massage section might slide,
and injuries may occur.
Advertisement
Chapters
Table of Contents
