Table of Contents
Advertisement
Setting up the massage lounger
1) Checking the accessories
●
Armrests (Right/Left) The holes on the inside fabric are due to the manufacturing
Right/Left indication
(armrest back)
2) Where to use the unit
Ensure there is adequate space to recline.
●
Dimensions required for installation ( see page EN46 for the detailed dimensions of the main unit)
Height 115 cm × Width 95 cm × Depth* 222 cm
* The main unit is approx. 202 cm in length, and it is necessary to keep it more than 10 cm from obstacles such as walls,
so a length of 222 cm should be reserved.
●
Do not expose the massage lounger to direct sunlight or high temperatures.
This can cause discoloration or hardening of the synthetic leather.
3) Installing
Hold the legrest by the sides
EN10
process and are not a fault.
●
Pillow
●
Power cord
Place your fingers in
the groove
Hold the legrest with your hands until it has
been set on the floor completely.
If you release the legrest too soon, it will
spring back to the initial position.
●
Comfort cushion
①
The unit must be carried by two or
more persons.
ㅡ Since the unit is heavy, be careful to avoid
back injuries.
Unit weight
Approx. 87 kg
②
Watch your step carefully and put
down the unit slowly.
Lay out a mat etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the size
of the mat should be sufficient (at least
120 cm × 70 cm) to cover the areas where
the unit touches and where the legrest
could touch the floor.
■ Do not hold onto the front side!
The sole massage section might slide,
and injuries may occur.
Advertisement
Chapters
Table of Contents
