Table of Contents
Advertisement
Setting up the massage lounger
1) Checking the accessories
●
Armrests (Left/Right)
Left/Right indication
(armrest back)
2) Where to use the unit
Ensure there is adequate space to recline.
●
Unit body dimensions
(See EN49 for detailed unit dimensions.)
* When installing near a wall, etc.
In the reclining state, make sure that the backrest and the legrest are away from walls, etc., by 10 cm or more,
and the armrest is away from walls, etc., by 5 cm or more.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
This can cause discoloration or hardening of the synthetic leather.
3) Installing
Hold the sides of the legrest.
EN10
Controller stand and
controller holder are
located on the right
armrest.
Height approx. 120 cm × Width* approx. 85 cm × Depth* approx. 200 cm
Place your fingers
in the groove
Hold the legrest with your hands until it
has been set on the floor completely.
If you release the legrest too soon, it
will spring back to the initial position.
●
Pillow
●
Power cord
①
The unit must be carried by two or more
persons.
• Since the unit is heavy, be careful to
avoid back injuries.
Unit weight
②
Watch your step carefully and put down
the unit slowly.
Lay out a mat, etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the size of
the mat should be sufficient (at least 120 cm ×
70 cm) to cover the areas where the unit touches
and where the legrest could touch the floor.
■ Do not hold the foot part!
The sole massage section might
slide, and injuries may occur.
●
Comfort cushion
Approx. 87 kg
Advertisement
Chapters
Table of Contents
