Table of Contents
Advertisement
Question
How to adjust the <Intensity>
The auto course is "not strong
enough even at the strongest
setting..." or is "too strong
even at the weakest setting...".
The hip massage is weak ...
The intensity in the left hand
& arm differs from that in the
right.
I hardly feel any difference in
intensity in the sole roller even
after adjustment ...
Sole roller is too intense even
at the gentlest setting ...
Other
The controller holder is
unsteady.
The noise grows louder after
using the chair for a long time.
Try the following methods.
●
When the auto course is not strong enough even at the strongest setting,
recline the backrest. The extra body weight adds intensity to the massage.
●
When the auto course is too strong even at the weakest setting, place a
piece of fabric or blanket between you and the backrest to decrease the
sensation of the massage heads.
Please sit further in.
When you sit further in, the gap between the backrest and the
hip becomes smaller, making it easier for the massage heads to
contact your body. (Page EN38)
Only one hand at a time is strongly massaged so that the massage
can be immediately stopped using the other hand in the event of
an abnormality or danger.
The sole roller intensity is adjusted by the strength of the foot
side air pressure holding the soles. Therefore, depending on the
operating pattern, intensity difference may not be felt.
Try the following method.
Slightly lower the sole massage section so that the heel is raised
above it, which will weaken the effect of the roller.
Tighten the controller holder fixing screw.
●
If the controller holder comes off, loosen the controller holder fixing screw,
place the holder in and tighten the fixing screw again.
This may be a malfunction. Contact the nearest authorized service
center for an inspection and repair.
Answer
Controller holder
Controller holder fixing screw
▶
Continued on the next page
EN47
Advertisement
Chapters
Table of Contents
