Table of Contents
Advertisement
Setting up the massage lounger
1
Where to use the unit
●
Ensure there is adequate space to recline.
Keep at least 10 cm (3.9 in.) away from the wall.
Approx. 49 cm
(19.3 in.)
Mat
Area where leg rest
could touch the floor
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of
heating sources, because this can cause discoloration or hardening of the synthetic leather.
●
Place the unit on a mat to prevent floor damage. When placing a mat under the unit, the size of
the mat should be sufficient (at least 120 cm × 70 cm (47.2 in. × 27.6 in.)) to cover the areas
where the unit touches and where the leg rest could touch the floor, as shown in the diagram
on the above.
●
Install the unit near a power outlet.
2
Confirm that the main unit and the accessories are in the box.
Main unit
Controller
EN14
EP-MA73_EN.indb 14
Approx. 202 cm (79.5 in.)
Width approx.
Approx. 30 cm
90 cm (35.4 in.)
(11.8 in.)
Area where unit
touches the floor
Accessories
●Armrests (Right/Left)
Right/Left indication
(Back of the armrest)
The holes in the fabric
at the back of the
hand & arm massage
section are due to
the manufacturing
process and are not a
fault.
●
For details on the dimensions of the unit, see
page EN9.
●Pillow
●
A llen key — 1
(Cross-section)
●
C omfort
cushion
4 mm
●Controller stand
Controller
holder
Controller
●
holder fixing
P ower cord
screw
Clip
●
A ttachment screws
(M6 × 13) — Black
(4 pcs.)
(M6 × 20) — Silver
(2 pcs.)
●Lock switch key
This is initially inserted
in the lock switch of the
power switch section
prior to leaving the
factory.
2014-4-24 10:24:02
Advertisement
Table of Contents
