Box Contents; Wifi Set-Up - zappi -2H07UW-G User Manual

6. Box Contents

Tethered Units
1 x zappi unit with EV cable and connector attached
•
1 x Cable wall guard
•
1 or 3 x CT clamps
•
1 x Mounting template
•
1 x Mounting kit for a brick wall
•
Mounting kit (Tethered units)
4 x 50mm Pozi screws
•
4 x Wall mounting plug
•
4 x Sealing washer
•
4 x 12mm Pozi screws (countersunk)
•

7. WiFi Set-up

If WiFi was not available during your installation, your installer may have skipped this step. As soon as you have
WiFi availability you can connect by following the steps below.
It is important to connect your zappi to the internet to install the latest firmware and receive any future firmware
updates.
Step 1:
Firstly, turn on the Access Point by navigating to Menu > Other Settings > Internet > WiFi > WiFi
Information on your zappi device display. If Access Point is showing as "Off", turn to "On".
S te p 2:
Once the Access Point is set to "On", go back to the "WiFi" page by pressing the (
Step 3:
Connect your smartphone or computer to the myenergi access point by entering your phone or
computer WiFi Settings and searching for the network displayed with the same name as the SSID you noted down
above. Once displayed, select the network to connect.
Step 4:
You will be prompted for a
password.
Enter the password displayed on the
zappi screen that you noted down at
step 2.
1xCT clamp supplied with single phase zappi; 3xCT clamps supplied with three phase zappi
1
1
NOTICE
Make a note of the SSID and Password (P/W) now, for use in the next steps.
Untethered Units
1 x zappi unit
•
1 or 3 x CT clamps
• 1
1 x Mounting template
•
1 x Mounting kit for a brick wall
•
Mounting kit (Untethered units)
4 x 50mm Pozi screws
•
4 x Wall mounting plug
•
4 x Sealing washer
•
≡
) button.